Wallmarx Mounting Instructions

• Sponge
• Warm Water
• Masking Tape (One person application)
• Flat Wallpaper Seam Roller

1. Wallmarx adhere best to a variety of smooth surfaces including flat, semi gloss and gloss painted interior walls, as well as windows. The logos may also be applied over sealed wallcoverings that are smooth and clean. Wallmarx logos are NOT warranted for exterior use.
2. The surface must be clean and dry. Prior to installation, clean ;the wall with a damp sponge using warm water. It is recommended that you DO NOT use soap or cleaning agents. Let the wall thoroughly dry before the Wallmarx logo is applied.
3. If two people are present, one person should hold the top corners of the sheet to a table so that the other can carefully remove the logo from the backing. Tape can be used if two people are not present. DO NOT DISCARD THE PAPER BACKING, AS YOU MAY NEED IT AGAIN.
4. Apply the logo to the wall being careful to smooth out any bubbles as you go with a flat wallpaper roller.
5. Set the edges firmly with the wallpaper roller. DO NOT USE A SHARP TOOL TO SMOOTH THE SURFACE AS THIS MAY SCRATCH YOUR LOGO.
6. If you make a mistake, carefully remove the logo from the wall and re-apply.
7. If the adhesive sides touch, carefully pull them apart and continue.
8. Save the backing and the tube in case you decide to move your logo. Remove the excess white vinyl from the backing and discard it, roll the paper up and place it back in the tube.If you decide to move your logo, you can place it back on the backing, roll it up and place it back in the tube until you decide to remount it.